Development Server. Visit surplussales.com for the live site

Satfind-406 M3 EPIRB Satellite Beacon

Satfind-406 M3 EPIRB Satellite Beacon

Part Number:
(MIS) SATFIND

Product Details:
We have run into a batch of FACTORY NEW, IN THE BOX, EPIRB's that you can purchase at a fraction of their original cost. All original paperwork, registration cards and manual are included.

Emergency beacon transmits two radio signals at time of distress which is then detected by a passing satellite and relayed to SAR (Search And Rescue) program participants who then can coordinate a prompt rescue.

Distress signals are transmitted on 406.025 MHz and 121.5 MHz and contain the buoy's serial number, which has been properly registered before hand. Mission Control Centre receives the signal and alerts proper authorities in the area. A powerful strobe activates on buoy top.

Unit is about 8-1/2" diameter and 26" long. Manufactured in June of 1994. Standard maintenance requires battery replacement at regular intervals. The existing battery should be considered expired. We dismantled a battery pack and discovered five "D" size Lithium Manganese Dioxide 3v cells in series for 15v total. This Saft LM Series battery is known for it's extreme shelf life. The original pack actually used only about 1/3 of the space in the battery chamber. The balance was filled with expanding foam. We do not encourage the use of our EPIRB on vessels REQUIRING an emergency beacon by law if outfitting it with anything other than the factory approved pack. Last we checked the factory had stock but they were hideously expensive. Our target is smaller vessels that would like to have a Satfind but cannot afford the newest model.


M3 EPIRB Satellite Beacon
FACTORY NEW, IN THE BOX, EPIRB's that you can purchase at a fraction of their original cost
Distress signals are transmitted on 406.025 MHz and 121.5 MHz
8-1/2" diameter and 26" long

Share this page

$139.00

/ each

Qty

FREE Ground Shipping! On orders over $100

Related Products
3 µF 370vac Motorstart Capacitor

Part #: CFO P150F1002

Description: 3 µF 370vac  Aerovox, QD spade t…

Red LED

Part #: SDI CMWOR01R

Description: Red LED. T1. Right angle. 0.122" bulb diamet…

19 ohm − 25w Wire Wound Resistor

Part #: RWF WL19-25

Description: 19 ohm − 25w Brown Devil With tab terminals…

Connector

Part #: CON MS20P-124

Description: Burndy 20 pin connector with MSH20-41 backshell. …

Brand: Burndy

Featured Products
2.2 µF 250 vdc, 10% Metalized Polyester Capacitor

Part #: MMC225K250BIXF

Description: 2.2 µF 250 vdc, 10% Met…

PC Mount Relay

Part #: KO 12MBNR

Description: Goldstar PC mount relay. 12v DC coil, SPST, norma…

Brand: Goldstar

Standard Lug Type Terminal Strip

Part #: TSL 03-2-1G

Description: 3 lug, 1 grounded, 3/8" c&mi…

Pushbutton Switch

Part #: SWP 30262-11-C18P

Description: Staco pushbutton switch. 2P2T, 1 position momenta…

Brand: Staco